Pit report · November 9, 2026

Contract miner vs owner-operator fleet: how to tell them apart in satellite imagery

Aerial view of a large open-pit mine with terraced rock benches and a forested ridge behind it.

A pit on a satellite pass doesn't tell you who's running it. It gives you a bench full of yellow, orange, maybe a few other liveries, and it's on you to work out whether that mix is the mine owner's standing fleet or a contractor's roster rotating through on a tender. Get that distinction wrong and you'll log a contractor's roving trucks as part of the owner's permanent capital stack, then watch your count go stale the moment that contractor rolls off to the next job. Contract miner trucks don't belong to the site. They belong to the contractor, and they'll show up at the next job too.

The tell is in the mix, not just the brand

Owner-operators buy for the life of the pit. They standardize on one, maybe two OEM relationships across the truck and loading fleet, because parts support, operator training and maintenance contracts all get cheaper when the fleet is uniform. Once that fleet is in, it tends to hold its ratio of haul trucks to excavators to dozers for years. A truck-to-shovel match that was set at commissioning is still roughly the same match five years later, unless there's a documented capital upgrade.

Contract miners look different because they're not buying for one pit, they're redeploying a pool across whatever jobs they're currently contracted on. You'll see mixed model years of the same OEM parked on one bench, a haul fleet that doesn't cleanly match the loading units in age or generation, and support equipment that looks thinner relative to truck count than an owner-operator would run. A contractor is usually paid on tonnes moved, not on how tidy the fleet looks, so the ancillary ratio (dozers and graders per truck) tends to run lean compared to what an owner would specify.

None of this is a single-pass call. It's a pattern you build by watching the same pit across multiple monthly images and comparing the roster to what you'd expect from a capital fleet plan versus a contractor mobilization.

Watch what happens at a contract changeover

Changeover speed is what gives a contractor away. An owner-operator fleet renewal is gradual. Trucks get swapped out in batches over a year or two as the capital plan rolls through, so month to month the OEM split drifts slowly. A contract changeover looks nothing like that. One monthly pass shows the incumbent's trucks and loaders on the bench, the next shows a near-total swap, different OEM, different liveries, sometimes different equipment classes entirely, inside a single reporting cycle. That abrupt, wholesale turnover at one pit is a contractor rotation, not a fleet upgrade, and it's usually worth flagging before it shows up anywhere else.

The other confirming pattern is geographic. If you're tracking several pits in a region and the same unusual OEM mix, the same mismatched truck-and-loader generations, keeps turning up at different sites a few months apart, that's a contractor's fleet moving job to job. An owner-operator's trucks don't travel between pits. A contractor's do, and once you've seen that mix once, you'll recognize it on the next contract they pick up.

Building that recognition by hand means pulling every pit in a region on repeat and keeping a manual log of what's parked where each month, which gets slow once you're tracking more than a handful of sites. Mine Fleet OEM Share builds that pit-by-pit roster automatically on a monthly pass, with manufacturer-type counts you can line up over time to spot exactly these changeovers without walking onto anyone's lease.

If you're trying to separate contractor turnover from genuine fleet renewal across a region's pits, that's the use case this is built for.

Start a pilot

← Back to the blog